Assignment in the area of Model Components

All settings and assignments of the model components can be made in the upper menu bar under the tab of Model Components. In this area, it is possible to easily create, structure and manage models, elements, geometries, properties and values.

Basically, it is recommended to create and edit model components in this area because it is much easier to manage the data from here than in the requirements area. For this reason, the following procedure is recommended for assigning the model components to the Requirements area:

1. On the tab Model Components > Requirements Setup,all elements, geometries, properties and values can be assigned to an individual model.

2. The data structure of the project guideline is shown on the left, while the structure of the selected model for the requirements is shown on the right. The selected element can be dragged into the desired model by using the drag and drop function.

The desired element is assigned to the corresponding model and is also included in the requirements area. Model elements from the guideline used should be assigned to the right place in the model. Commands that cannot be carried out are indicated by a red cross.